Coast Spas

Coast Spas North American VEL100 spa pack, a compact control system for smaller spas. It runs the pump, heater and lighting, and handles temperature and filtration based on the keypad settings. Fits...

Coast Spas motion sensor switch that turns a connected function on automatically when movement is detected. It adds hands-free convenience, such as activating lighting as someone approaches. Fits...

Coast Spas main board only, made for a specific spa pack and sold without the enclosure or heater. The board houses the control circuitry that switches pumps, heater and lights. It is a...

Coast Spas M7 sensor with 24-inch length, packaged with its nut, O-ring and gasket. It reports water conditions to the spa pack so heating and safety functions work correctly. The longer length suits...

Coast Spas M7 sensor in the 14-inch length, supplied with a nut, O-ring and gasket for a sealed installation. The sensor lets the control system monitor water conditions so the pack can regulate...

Coast Spas in.ye-6 spa pack, the main control system that operates pumps, heating and accessories. It follows the settings and filtration schedule entered at the keypad and keeps the water at the...

Coast Spas in.touch 3 connectivity device that brings app-based control to a compatible spa pack. Through a phone or tablet, you can adjust water temperature, start pumps and monitor the spa remotely...

Coast Spas high-end four-pump pack designed for swim spas that run several pumps for swimming current and therapy jets. It centralizes control of the pumps, heater and accessories in one enclosure...

Coast Spas harness for DM5 that connects the DM5 component to the spa's control system. A good harness keeps power and signals flowing reliably between devices. Fits select Coast Spas Elite,...

Coast Spas generic pack overlay for BP100 and BP200 spa packs, the label panel that sits on the pack enclosure. It identifies connections and outputs so wiring and service work are easier to follow...

Coast Spas Gecko YE-5 spa pack with a built-in 5.5 kW heater that can drive up to three pumps. Two outputs support two-speed pumps and the third runs a single-speed pump or blower, at 120V or 230V;...

Coast Spas GFCI wire, listed as the 15 version, made to connect the ground fault circuit interrupter for the North American VEL100 pack. It carries power from the GFCI protection to the pack so the...