Coast Spas

Coast Spas 3.0kW heater with sensors, supplied without a tailpiece. The element warms the water while the sensors report temperature to the control for safe, accurate heating. Because the tailpiece...

Coast Spas 240-volt fan that moves air through the equipment area to keep pumps and electronics from overheating. Good airflow can extend component life, especially in warm climates. Fits select...

Coast Spas 2015 Elite BP2100 Skinny spa pack in the EU configuration. The control pack manages pumps, heater and filtration, set up for European electrical service. Fits select Coast Spas Elite,...

Coast Spas 2015 expansion board for BP501 and BP2100 control systems. It adds extra outputs to the main pack so the spa can run additional equipment. Fits select Coast Spas Elite, Luxury, Classic and...

Coast Spas 2-pin 16-gauge trailer-style hookup connector for low-voltage wiring. The two-pin plug makes it easy to connect and disconnect a pair of wires on accessories. Fits select Coast Spas...

Coast Spas 15-foot communication cable that carries data between the spa control and a topside panel or other connected component. The longer run suits swim spas where the controls sit far from the...

Coast Spas 110V Silk white goods, the core electrical and equipment set used on 110V Silk-style systems. It brings the components needed to run, heat and filter a household-voltage spa. Fits select...

Coast Spas 110V BP501MS Silk spa pack, the control system that runs the pump, heater and lights on a 110V supply. It handles filtration cycles and heating, taking commands from the topside panel...

Coast Spas 110V conversion set for the BP2000 control system. It allows a BP2000 pack to be set up for 110V operation instead of its standard supply. Fits select Coast Spas Elite models. Converting...

Coast Spas 10A/3.5A two-speed pump supplied with unions and a 6-foot amp power cord. The ratings reflect the current draw on high and low speed, so it powers jets on high and circulation on low. Fits...

Coast Spas 4 horsepower wet end with a 2-inch intake that fits 48 or 56 frame motors. It replaces the housing and impeller portion of the pump, restoring flow without changing the motor. Confirm your...

Coast Spas replacement pump wet end, the water-moving section containing the housing and impeller. Replacing it restores a pump with a cracked body, leaking seal area or worn impeller while reusing a...