Coast Spas

Coast Spas 2-inch slip x slip coupling for connecting two straight runs of 2-inch pipe end to end. Pipe is cemented into each socket, making it a simple way to extend a line or patch a section...

Coast Spas 2-inch slip x slip coupling that joins two lengths of 2-inch pipe in a straight line. It is the go-to fitting for splicing in a repair after cutting out a cracked or leaking section of...

Coast Spas 2-inch slip x slip 90-degree elbow used wherever a 2-inch line must turn a corner. Gluing pipe into both sockets gives a solid, leak-free bend, useful for rebuilding a damaged section of...

Coast Spas 2-inch slip x slip 90-degree elbow for making right-angle turns in main circulation plumbing. Each end is a socket that takes 2-inch pipe, a common fitting when replacing cracked or...

Coast Spas 2-inch slip x slip 45-degree elbow that lets a plumbing run change direction at a moderate angle. Pipe glues into each socket end, making it handy for offsetting a line around the pump,...

Coast Spas 2-inch slip x slip 45-degree elbow for angling main plumbing lines at a gentle bend. Both ends are sockets that accept 2-inch pipe, so it can redirect a run around equipment with less flow...

Coast Spas 2-inch slip plug used to seal the end of a 2-inch socket where a line or port is no longer needed. Solvent-cemented in place, it stops water from escaping a dead-end fitting during repairs...

Coast Spas 2-inch slip plug that caps off an open 2-inch socket fitting, closing unused ports or lines in the plumbing. It glues into the fitting to create a permanent watertight end. This plug is...

Coast Spas reducer fitting with a 2-inch spigot end stepping down to a 3/4-inch ST BR connection. It joins a large-diameter line to a much smaller one, typically where a branch line or accessory...

Coast Spas 2-inch slip by 2-inch spigot 90-degree elbow used to turn main plumbing lines a full right angle inside the equipment bay. One end accepts pipe into its socket while the spigot end slides...

Coast Spas 2-inch diverter primary cap in a shallow profile. This cap closes off the top of a 2-inch diverter valve body and holds the internal stem in place so the valve can redirect water between...

Coast Spas 2-inch diverter primary cap in clear, made for Aura series diverter valves. It seals around the valve stem to keep water inside the valve body, and the transparent shell lets you see...